Before I go nuts trying to figure this out.  Can something like this be done in
Korn shell?
---------------------- Forwarded by Lucy Premus/Bsg/MetLife/US on 03/09/99 09:23
AM ---------------------------


Nicaud Phil <pnicaud AT WOOLWORTHS.COM DOT AU> on 03/07/99 04:24:28 PM

Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
      <NV-L AT UCSBVM.ucsb DOT edu>

To:   NV-L AT UCSBVM.ucsb DOT edu
cc:    (bcc: Lucy Premus/Bsg/MetLife/US)
Subject:  Re: comparing address ranges in a script




Perfect opportunity for a Perl script

Phil

> -----Original Message-----
> From: Lucy Premus [SMTP:lpremus AT METLIFE DOT COM]
> Sent: Saturday, 6 March 1999 5:03
> To:   NV-L AT UCSBVM.ucsb DOT edu
> Subject:      comparing address ranges in a script
>
> Is it possible to do a comparison of say an IP address to an IP address
> range
> (similiar to what would be defined in a seed file) within a script?  For
> example, I want to compare the following:
>
> address range  address
> 10.20.*.1-100       10.20.7.34     matches
> 10.7.1-7.*          10.7.9.20 doesn't match
**********************************************************************
CAUTION: This Message may contain confidential information intended
only for the use of the addressee named above. If you are not the
intended recipient of this message you are hereby notified that any
use, dissemination, distribution or reproduction of this message is
prohibited. If you received this message in error please notify
Mail Administrators immediately. Any views expressed in this
message are those of the individual sender and may not necessarily
reflect the views of Woolworths Ltd.
**********************************************************************