Re: Cisco Device packages
1999-01-28 16:57:14
Ours works.
On the routers make sure you have
access-list 1 permit xxx.xxx.xxx.xxx (ip address of SNMP device - netview
machine)
snmp-server community Public RO 1
snmp-server community Private RW 1
On the Netview machine you'll need to configure your SNMP options;
To modify entries in this file, use the SNMP Configuration commands
which are accessible through the X11/Motif graphical user interface
(OVW menu: Options->SNMP Configuration) or through the xnmsnmpconf
command line options.
(from /usr/OV/conf/ovsnmp.conf)
The SNMP configuration will need to match your router community strings for
the device.
Good luck!
David Barrett
Network Design and Management
david.s.barrett AT bankamerica DOT com
"Radcliffe Jr, Arthur W" <arthur.radcliffe AT AETNA DOT COM> on 01/28/99
01:38:10
PM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on
NetView <NV-L AT UCSBVM.UCSB DOT EDU>
To: NV-L AT UCSBVM.UCSB DOT EDU
cc: (bcc: David S. Barrett)
Subject: Cisco Device packages
We have a number of Cisco Routers which are represented by the generic
router Symbol.
We recently Installed CiscoView and their device packages. Other than
deleting a Router object and rediscovering it, is there a way to have the
Routers display on the map, with the new
symbols? I tried demand polling and that did not work.
|
|
|