nv-l

Re: Router

1999-01-15 11:04:03
Subject: Re: Router
From: Marc Russo <mrusso AT AL.IISL DOT COM>
To: nv-l AT lists.tivoli DOT com
Date: Fri, 15 Jan 1999 10:04:03 -0600
Use the bandwidth command on each sub-interface.

interface serial 1.1
 ip address xxx.xxx.xxx.xxx
 bandwidth 56      <--- Set to the appropriate bandwidth
 frame-relay interface-dlci xxx

Marc Russo (mrusso AT al.iisl DOT com)
International Integrated Solutions, LTD


> -----Original Message-----
> From: Pradeep Menon [SMTP:pmenon AT EMAIL.MSN DOT COM]
> Sent: Friday, January 15, 1999 8:28 AM
> To:   NV-L AT UCSBVM.ucsb DOT edu
> Subject:      Router
>
> Hello,
>       Hi I am a newbie, I am using Netview 4.1 on an AIX 4.2 platform,
> I am capturing Interface Bandwidth utilization on routers, (mostly
> CISCO routers) through an mib expression via snmp collections. I have
> noticed that on partial serial frame relay interface, the speed did
> not match the actual bandwidth available.
>
>       What I mean is that if I have  serial0 interface multiple PVCs,
> with each PVCs catering to a site, when I query the isSpeed of these
> interfaces I get a full T1 speed instead of the partial speed
> information and as a result my calculation does not reflect the right
> reading.
> Any workaround this problem.
>
>       Any help will be greatly appreciated.
>
> Thanks
> Pradeep Menon
> Synapse Computer Services Inc
> Tel : (O) - 908-526-8488 x 27
> Email : pmenon AT msn DOT com

<Prev in Thread] Current Thread [Next in Thread>
  • Router, Pradeep Menon
    • Re: Router, Marc Russo <=