> I'm sorry, but I'm afraid to tell you that this problem hasn't been solved
> until now: we just had this problem on 5.1 with a daemon (in our case
> lannetDM from MADGE MultiMan) in case of starting the gui and stopping the
> gui before  a certain process is up and running (in our case it's the zoom
> process from MADGE MultiMan).
> Our "workaround" is:
> 1. be careful with stopping a netview gui in the startup phase
> 2. if you stop it for all that, then check the nv6000.log
> 3. if you see this dirty stuff, then kill the right process (if you know
> it) and clear the nv6000.log
> 4. drink a beer (or something similar) to calme down.....
> 5. Try it again... (goto point 1..... or better go directly to point
> 4....)
>
> hope this helps a little bit
>
> Herbert Adamczyk
> iT-AUSTRIA
> Network-Management
>
>
>
>
> ----------
> Von:  Mario Beck[SMTP:mariobeck AT GMX DOT NET]
> Gesendet:     Mittwoch, 16. Dezember 1998 15:56
> Betreff:      Select failed; error code 9
>
> Hi,
>
> I've the following problem:
> When I try to read out a SNMP device by the MIB browser, sometimes there
> is the warning output in the nv6000.log and the aixterm (tee nv6000.log):
>
> Warning: Select failed; error code 9
> Warning: Select failed; error code 9
> Warning: Select failed; error code 9
> ...
>
> I cannot stop this output.
> I cannot close the MIB browser window normaly.
> When I close the NetView GUI the output doesn't stop.
>
> Our installation:
> AIX 4.2.1
> NetView 5.0
> NWays 1.2.1
>
> Is there a workaround or a PTF?
>
> Thanx & Bye
> ---
> Sent through Global Message Exchange - http://www.gmx.net
>
>