Re: Change Of NV6K IP ADDR
You said pings and demand polls work fine, but if netmon is turning your
interfaces red, it is because its pings are timing out. I suggest you run
xnmsnmpconf and look at the default timeouts for these interfaces and see
about raising the timeout a bit.
Tivoli (NetView for UNIX) L3 Support
Gil Irizarry <IRIZARRG AT LABS.WYETH DOT COM> on 09/18/98 10:56:32 AM
Please respond to Discussion of IBM NetView and POLYCENTER Manager on
NetView et alia <NV-L AT UCSBVM.UCSB DOT EDU>
To: NV-L AT UCSBVM.UCSB DOT EDU
cc: (bcc: James Shanks)
Subject: Change Of NV6K IP ADDR
I have a RISC6K F50 with FDDI, Fast Ethernet & 10 meg Ethernet. I have
default gateway from the 10 meg to the FDDI nic. The FDDI connects to a
concentrator that also houses the router with the IP address I am using as
Now, NETMON is detecting "interface down" alerts frequently on all my
interfaces. Shortly after, I see the "interface up" alert and all my router
icon turn green
I did run reset_ci after my change. Is there another utility needed?
netstat -nr shows:
"default xxx.xxx.xxx.xx UG 23 767159 fi0 -
-" Where xxx is the IP
address I have specified as the default gateway. Pings & demand poll work
The last entry on the display shows:
"www.www.ww yyy.yyy.yyy.yyy.yyy U 159 771354 fi0 - -"
Where www is the
subnet and yyy is the IP address of my Netview box.
NV4.1.2 PTF LVL U453385
Thanks in advance
280 King of Prussia Road
ST. Davids, PA 19087
Phone: (610) 902-3426
INTERNET: IRIZARRG AT LABS.WYETH DOT COM