I don't know why your second router is not being discovered (netmon
discovery is not something I do) but the usual suggestion is to add one or
two node to the seed file which are on the other side ot it and see if
netmon can discover those.  Then he'll have to add the router to connect
them.

Make sure you ovstop netmon when you update the seed file and then ovstart
him again so he picks up the changes.

James Shanks
Tivoli (NetView for UNIX) L3 Support


JMutrux AT GENAM DOT COM on 06/18/98 09:43:29 AM

Please respond to NV-L AT UCSBVM.UCSB DOT EDU

To:   NV-L AT UCSBVM.UCSB DOT EDU
cc:    (bcc: James Shanks)
Subject:  NetView not discovering nodes in next segment





I have the following network -

     Netview             10.1.1.12
     Cisco router             10.1.5.175 (token ring)
                         10.4.105.254 (ethernet)
     Cisco switch with RSM (router)      10.4.105.253

I am trying to discover a switch with address of 10.4.1.10.   The poll from
Netview at 10.1.1.12 would cross two routers (the two Cisco's).  Netview
does know about the first router but does not discover the next, even
though it is pingable and in the seed file.  How can I get it to see
further out?

John Mutrux