Re: [Veritas-bu] Restores using Virtual Centre under 7.5.0.3

Simon,

"The ["Clear lazy zero" ] message occurs when performing a restore of a VM to a virtual center console. It is just a message letting you know that the lazy zero bit is being cleared. It is not an error, and can be ignored".

It's just noise, so what's the problem? Besides, restoring directly to the ESX host is tons faster than restoring through the vCenter server...

Neil

On Feb 8, 2013, at 11:16 PM, Simon Weaver <Simon.Weaver AT iscl DOT net> wrote:

All

I am calling out to anyone using VMware API under 7.5.0.3

Please look at this technote...

http://www.symantec.com/business/support/index?page=content&id=TECH77784

I have raised a Ticket with Symantec, because I am quite unhappy that under 7.0 and 7.1 I was fully able to initiate restores under Virtual Centre fine, without Clear Lazy Zero's but now it seems I have to perform restores direct to the ESX Server.

What is the point of the vCentre option being there if it cannot be used?

I have a RegKey entry called No eagerly scrub but it does nothing.

Do others see this problem?

Simon
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu