Hi,

I have a problem seeing the changer and tape device on a Sun T5220 Solaris 10 
server with 2 x QLC HBA's installed.

Ive logged the problem with Sun but they advise me to install to the latest 
patch level etc etc which unfortunately at the moment I cannot do due to 
downtime restrictions. 

Storage have told me I should be see 1 changer and 2 tapes drives

Basically I can see the ADIC Array controller from sgscan as below:

/dev/sg/c0t0l0: Disk (/dev/rdsk/c1t0d0): "SEAGATE ST914602SSUN146G"
/dev/sg/c0t1l0: Disk (/dev/rdsk/c1t1d0): "SEAGATE ST914602SSUN146G"
/dev/sg/c0tw500308c0019178b2l0: Array-controller: "ADIC    Scalar i2000"

However I should be seeing the changer and 2 tape drives.

Ive followed the notes from the admin guide (sg.install, sgbuild etc) to no 
avail. I did see a thread on the same lines 
(http://www.adsm.org/lists/html/Veritas-bu/2006-06/msg00065.html) which said 
the LUN mapping was wrong so if anyone could assist it would be appreciated.

The days of physical tape's being attached are nearing an end I think 
unfortunately.



Thanks...

+----------------------------------------------------------------------
|This was sent by steven.hoyle AT virgin DOT net via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu