Hi Ahmad,
The section IV “SAN Client
and Fibre Transport” in “NetBackup Shared Storage Guide” has the
configuration and installation steps.
http://seer.entsupport.symantec.com/docs/290238.htm
Hope this helps.
Thanks,
Tanuja
From:
veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Ahmad Abbas Ilyas
Sent: Monday, January 18, 2010
8:42 PM
To:
veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] Help -
Configure FT Media and SAN Client on Netbackup6.5
Hi
all,
I
was tried this link below, but the backup not throught over Fibre
Transport. It still over to the LAN transport.
http://seer.entsupport.symantec.com/docs/288437.htm -
NetBackup SAN Client and Fibre Transport Troubleshooting Guide (Revision E)
(updated January 11, 2010)
Can
anyone send me the specific guidance (point per point) how to configure
FT Media and SAN Client on Netbackup 6.5 (Platform Windows) ?
Thanks
in advance.
Regards,
Ahmad
Abbas ilyas
PT Mitra Integrasi Informatika
Support Services Department
Wisma Metropolitan 1 Lt.6
Jl. Jend Sudirman Kav 29-31 Jakarta Indonesia
Mobile: (+62)
8788 3955558