Double-check your config against this doc:
ftp://exftpp.symantec.com/pub/support/products/NetBackup_Enterprise_Serv
er/267773.pdf

Ensure that these 2 commands are successful:

tpautoconf -verify <celerra_host>

tpautoconf -probe <celerra_host>

Regards

Marianne

-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of
bamabreeze87
Sent: 15 October 2009 02:47
To: VERITAS-BU AT MAILMAN.ENG.AUBURN DOT EDU
Subject: [Veritas-bu] NMDP backups on EMC Celerra Netbackup 6.5.3


Hello,
I have a problem. I am running ndmp backups using netbackup 6.5 Windows
server 64bit R2 2003 on a EMC Celerra NAS. I cannot create ndmp tape
drives on the netbackup admin console. So at the moment my configuration
is running over the Ethernet network and is causing issues. 

I need help!!! 

When I try to add a tape drive in the admin console I get an error 16,
unable to verify host. 

The host is registered on the netbackup server (server_2). I have
verified the device file name is accurate c1202020 ish. 

Anyone with some insight please respond. I appreciate your help.

+----------------------------------------------------------------------
|This was sent by jonathanpbryant AT hotmail DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu