Re: [Veritas-bu] Drive cleaning
2009-08-13 16:05:23
This is probabaly too obvious, but if your drives are HCART then the
tapes are HCART and the cleaning tapes should be HC_CLN...If you aren't
defining the cleaning tapes as the same type as the drives, then it will
fail.
HCART drives --> HCART media --> HC_CLN cleaning tapes
HCART2 drives --> HCART2 media --> HC2_CLN cleaning tapes
HCART3 drives --> HCART3 media --> HC3_CLN cleaning tapes
Hope this helps.
Scott Chapman
Senior Technical Specialist
Storage and Database Administration
ICBC - Victoria
Ph: 250.414.7650 Cell: 250.213.9295
-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of
smwoodcrafts
Sent: Thursday, August 13, 2009 12:52 PM
To: VERITAS-BU AT MAILMAN.ENG.AUBURN DOT EDU
Subject: [Veritas-bu] Drive cleaning
This is driving me crazy. We have 5 sites with backup environments .
Four of them have a Quantun i500 and the largest has a i2000. They all
have LTO4 drives. We are using TDK universal LTO cleaning tapes. I
created a barcode rule so that they are recognized as Hcart cleaning
tapes.
I have tried to clean the drives through the Admin console and using
tpclean and both methods fail on all libraries. How does everyone else
clean their drives?
+----------------------------------------------------------------------
|This was sent by dseymour AT ap DOT org via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|