Re: [Veritas-bu] Incorrect Storage Unit
2009-07-02 12:52:38
If you did it too fast, changes to policies can take up to 10 minutes to
be implemented (by default).
-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Heathe
Kyle Yeakley
Sent: Thursday, July 02, 2009 10:40 AM
To: VERITAS-BU AT MAILMAN.ENG.AUBURN DOT EDU
Subject: [Veritas-bu] Incorrect Storage Unit
I have installed a new tape library(tld1). I still have my original
library (tld0) connected. I've taken a couple of policies, copied them
to new policies and changed only the storage unit within the policy from
media-server-tld0 to media-server-tld1. I manually executed a test
backup of PolicyA-TLD1 and saw exactly what I expected to see: The
policy contacted the new robot, mounted a new tape and ran the backup on
the new library, finishing with status code 0.
When I do the same thing with a second policy, PolicyB-TLD1 is
contacting the original library, mounting tapes in the original
library... etc. It finishes successfully, but I can't figure out why it
isn't contacting the new library. I've gone back in and made sure that
the storage unit in PolicyB-TLD1 is TLD1 and not TLD0, and it is set
correctly.
Any thoughts while I dig around the Symantec website?
Thank you.
- Heathe Kyle Yeakley
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|