Hi,

I have two media servers (one media server is also my master server). The 
second media server (Solaris 10, NBU 6.5) is seeing all the tape drives when I 
run sgscan or the device config. wizard in the NBU console. However, when I go 
to devices -> media servers-> <media server name> it shows up as Active for 
disk.

When I run the vmoprcmd command on the master the server shows up as 
ACTIVE-DISK.

How can I change it to make the server Active for disk AND tapes.

Thanks in advance for your help

+----------------------------------------------------------------------
|This was sent by s.mehta AT ieee DOT org via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu