I have a 3576,  I had to install the ATAPE file set on my AIX box before
I could see the ovpass in my lsdev.

-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of rvadde
Sent: Thursday, October 23, 2008 3:19 PM
To: VERITAS-BU AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] IBM TS 3500 Tape Library Control Path Fail Over


Is there any one using IBM TS 3500 Tape Library Control Path Fail Over
using under netbackup?

IBM says to use this feature we need to use IBMtape driver. 

Symantec says we need to use only ovpass/sg driver for the robots. 

If we don't use Control Path Fail Over feature if a drive which has the
robotic control path fails we need to reconfigure the robotic path. Ugly
situation. 

Any suggestions/recommendations?

Thanks

+----------------------------------------------------------------------
|This was sent by rajesh_vadde AT fanniemae DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu