Jeff,
For what it’s worth
We have a similar setup except we use a
scaler i2000. Ours is a single large partition. All of our “partitioning”
is done with tape pools. I frankly don’t care which drive gets which job
or uses which tape, just so long as the stuff ends up on tape.
David Spearman
County of Henrico
From:
veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Jeffery Price
Sent: Thursday, October 09, 2008
1:17 PM
To:
veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] New NBU
6.5.2.a install - NDMP and LibraryPartitioning Question
Hi List,
We will have a new NetBackup 6.5.2 install on W2K3 R2 Server
(Master+Media), NDMP, and SSO Option. Connected via FC, and using Dell
PowerVault 6020 with 4 x LTO-4 drives, Celerra NS80.
Primary backup source will be Celerra via FC NDMP.
We will also be using the same library and master+media
server to backup distributed clients via network.
Any recommendations on partitioning the library?
Thanks.
--Jeff
________________________________________________________________________
This communication is for use by the intended recipient and contains
information that may be privileged, confidential or copyrighted under law. If
you are not the intended recipient, you are hereby formally notified that any
use, copying or distribution of this e-Mail, in whole or in part, is strictly
prohibited. Please notify the sender by return e-Mail and delete this e-Mail
from your system. Unless explicitly and conspicuously stated in the subject
matter of the above e-Mail, this e-Mail does not constitute a contract offer, a
contract amendment, or an acceptance of a contract offer. This e-Mail does not
constitute consent to the use of sender's contact information for direct
marketing purposes or for transfers of data to third parties.
This email has been scanned for all viruses by the MessageLabs service.