Do you select all mount points at the same restore? If yes,
then you will see only one job, but netbackup will restore all files in one
tape pass.
If you start 5 restores the you have to be fast (every restore
must start within 30 sec, by default). This can be changed from master server
properties.
stefanos
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Jeremy
Finn
Sent: Friday, August 01, 2008 3:26 PM
To: veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] Restoring from Multiplexed Backup
Hello,
I have a standard backup policy configured to stream five mount points to one
tape drive. This is working fine.
When I do the restore, I only see one stream restoring at a time. Is it
possible to restore the five streams of data from the multiplexed tape at the
same time?
Other backup softwarescan do this so I assume Netbackup can as well... if some
could please point me in the right direction it would be much appreciated.
My environment looks like this:
Master: Solaris 10 on SPARC
Media Server: HP-UX on PA-RISC
Source Client: HP-UX on PA-RISC
Target Client: HP-UX on PA-RISC
Multistream = 5
Multiplex = 5
One LTO-1 tape drive
Thank you in advance for any insights.
Jeremy