|
Re: [Veritas-bu] How to get capacity or type of tape media
2008-05-13 17:58:36
Shyam,
I looked at vmquery, but no luck. I want to get the tape type such as DLT, LTO, etc... I can at least hard code the raw capacity by tape type in to a script and use that as a look up, but I am trying to figure out how Netbackup knows the tape type.
Thanks,
Kevin
On Tue, May 13, 2008 at 4:34 PM, Shyam Hazari < shazari AT gmail DOT com> wrote:
Did you look at vmquery ? There is no way tot get raw capacity. You can get the used capacity of a tape using bpmedialist.
Hope this helps
-Shyam
All,
I am trying to figure out how I can get the capacity or type of tape media from NetBackup. I don't see anywhere where I can get Raw Capacity of a tape, but see that bpmedialist does show density. The problem is that I am seeing hcart instead of DLT or LTO, etc.... I have also tried vmquery -a, but that doesn't show me enough detail.
Is there anyway to get the actual raw capacity or actual media type from NetBackup?
Thanks in advance.
-Kevin
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|
