Folks,
I am in the process of building a v6.5 Master Server on
Solaris 10 in a VCS 5.0 framework. I have done the basic install and
tested the application will failover between the two nodes. However, I
now want to configure a couple of FC attached tape drives for the catalog
backups and am confused as to how to proceed. The documentation suggests
I attach the devices to both nodes and run device configuration from the active
node which means the device host will be the physical node, but do I make the
storage units point to the virtual node name and/or do I have to do something
clever with the EMM to tell it about the relationship between virtual and
physical hosts. There is talk of this in the documentation under the
description “application cluster” but is this what I have i.e.
netbackup as an application in a cluster?
Any guidance much appreciated.
Regards,
Paul Esson
Redstor Limited
Direct:
+44
(0) 1224 595381
Mobile: +44 (0)
7766 906514
E-Mail:
paul.esson AT redstor DOT com
Web:
www.redstor.com
REDSTOR LIMITED
Torridon House
73-75 Regent Quay
Aberdeen
UK
AB11 5AR
Disclaimer:
The information
included in this e-mail is of a confidential nature and is intended only for
the addressee. If you are not the intended addressee, any disclosure,
copying or distribution by you is prohibited and may be unlawful.
Disclosure to any party other than the addressee, whether inadvertent or
otherwise is not intended to waive privilege or confidentiality.