Folks,
I’m looking for some guidance on
configuring a clustered NetBackup Master Server. Can anyone share their
experiences with me?
The basic configuration is a two node
(V445) Solaris 10 cluster using Storage Foundation Standard HA 5.0. The
application is NetBackup 6.5 (Master Server). The shared storage is
delivered from two HP XP 12000 arrays. The nodes and the arrays are located
at separate sites approximately 13 km apart and there is a tape library and VTL
at each site too. There are 8 Media Servers, 4 Windows 2003 and 4 Solaris
10 none of which are clustered. There are 4 Media Servers at each site.
My main concern is in how to take the
catalog backup. Should I use a Media Server and avoid any device
configuration on the Master Server or does that compromise my recovery
capabilities if I have to restore the catalog? If I configure a tape
drive from each library on the Master Server cluster, how do I ensure that the
device configuration remains consistent across both nodes for these devices?
Regards,
Paul Esson
Senior Consultant
Redstor Limited
Direct: +44
(0) 1224 595381
Mobile: +44 (0) 7766
906514
E-Mail:
paul.esson AT redstor DOT com
Web:
www.redstor.com
REDSTOR LIMITED
Torridon House
73-75 Regent Quay
Aberdeen
UK
AB11 5AR
Disclaimer:
The information included in this e-mail is of a
confidential nature and is intended only for the addressee. If you are
not the intended addressee, any disclosure, copying or distribution by you is
prohibited and may be unlawful. Disclosure to any party other than the
addressee, whether inadvertent or otherwise is not intended to waive privilege or
confidentiality.