Hi all
Quick question - NBU 5.1 MP2 Win2k3 Server
 
One of our libraries has over 40 tapes taken out each and every month to be
stored in a safe.
 
Trouble is, it is a time consuming process to label each tape (not that I
mind too much!).
 
Anyhow, is there an EASY method or way to tell What data is on a tape via a
command line without the need to load the single tape into the library?
 
I could go through tapes one by one, but is there an easier method I am
overlooking?
Thank you
 

Regards

Simon Weaver
3rd Line Technical Support
Windows Domain Administrator 

EADS Astrium Limited, B23AA IM (DCS)
Anchorage Road, Portsmouth, PO3 5PU

Email:  <mailto:Simon.Weaver at Astrium-eads.net> Simon.Weaver at 
Astrium-eads.net

 


This email (including any attachments) may contain confidential and/or 
privileged information or information otherwise protected from disclosure. If 
you are not the intended recipient, please notify the sender immediately, do 
not copy this message or any attachments and do not use it for any purpose or 
disclose its content to any person, but delete this message and any attachments 
from your system. Astrium disclaims any and all liability if this email 
transmission was virus corrupted, altered or falsified.
---------------------------------------------------------------------
Astrium Limited, Registered in England and Wales No. 2449259
Registered Office: Gunnels Wood Road, Stevenage, Hertfordshire, SG1 2AS, England
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
http://mailman.eng.auburn.edu/pipermail/veritas-bu/attachments/20061108/ba0210d3/attachment.html