-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

what do you see when you...

cat /proc/scsi/scsi

If it isn't there, then your O/S isn't seeing the drives, check your
zones again.  Also, are you using the included qlogic driver to the
kernel (which distro and kernel are you using?)  or have you installed
the qlogic Linux drivers?  There shouldn't be a "driver" for the LTO3 drives,
it should be seen as a SCSI "st" device and the NBU install should set up
the SG driver correctly.

There are also great docs included with NBU for this.
I would also help when asking questions to supply all
the data needed:

- -O/S version and architecture?
- -NBU version and MP level?
- -which qlogic cards?

Thanks
Peter

Peter DrakeUnderkoffler
Xinupro, LLC
617-834-2352



Brooks, Jason wrote:
> We're testing a Linux media server now to try and resolve some NDMP
> issues.  I have the Media server set up, talking to my Master, fiber
> connectivity to a tape drive (properly zoned), but I can't find
> drivers.  I've contacted ADIC support, but they've been no help.  I've
> found IBM drivers (library contains IBM LTO3s), but they don't work for
> fibre attached, just SCSI.  The fibre attached drivers link to Emulex,
> but we have QLogic cards.
>  
> Now, I'm about at the end of my rope.  Any suggestions?  Contact Veritas
> support?  My last hope is to wait on my ADIC Sales Rep's Engineer.
>  
> Thanks,
> Jason
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu at mailman.eng.auburn.edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (FreeBSD)

iD8DBQFFP5M1l+lekZRM55oRAgnWAJ427l9vIRPhqHCtWVJaVUfgwY7gNACeOmhd
2LeaZXnqQeRnzo7Q8UO+uvo=
=onCD
-----END PGP SIGNATURE-----