[Veritas-bu] changing backup selection in a policy
2006-07-12 08:52:38
Subject: |
[Veritas-bu] changing backup selection in a policy |
From: |
SSSekhon at VASC.com (Sekhon Simrat S.) |
Date: |
Wed, 12 Jul 2006 08:52:38 -0400 |
Paul
The policy will backup E:\ as a full backup but it will only do
incremental for previous selections.
Simrat
-----Original Message-----
From: veritas-bu-bounces at mailman.eng.auburn.edu
[mailto:veritas-bu-bounces at mailman.eng.auburn.edu] On Behalf Of Paul
Keating
Sent: Wednesday, July 12, 2006 8:24 AM
To: veritas-bu at mailman.eng.auburn.edu
Subject: [Veritas-bu] changing backup selection in a policy
I don't have a windows client in the lab at the moment, otherwise I
would test this myself and not bother you fine folks.
I feel like I should know this, but I've been burned by
assumptions/beliefs before.
I currently have a windows policy with several clients and a "backup
selections" list of C:\, D:\ and System_State:\
One of the machines has a new volume added mounted as E:\, so I want to
add E:\ to the list......will adding an entry for E:\ in the list trip
the policy up so as to run all incremental backups as "FULL"?
I don't mind that this one client will pick up the E:\ drive as "changed
since full" untill the next full, as it isn't too big.
I think not, as the policy name has not changed....each client should go
on as usual, knowing it previously had a good FULL with the same policy
name, search the system for the new drive letter, then move on, if it
doesn't exist....correct?
Paul
|
|
|