[Veritas-bu] vmchange -e question
2004-06-07 10:23:35
Hello
My understanding of vmchange -e was that it waited until the cap was emptied
before ejecting the next tape.
Setup a Overland robot with LTO-drives and one cap. This is what I get in the
log:
################ Ejecting todays duplicate tapes ####################
Could not eject TLD volume: Media access port already contains media (221)
make sure you remove E465L1 from slot 6 of robot number 0
Could not eject TLD volume: Requested tape in other or non-configured drive
(215
)
make sure you remove E469L1 from slot 10 of robot number 0
Any suggestions/idea's
Regards
Michael
--
Cybercity Webhosting (http://www.cybercity.dk)
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Veritas-bu] vmchange -e question,
ida3248b AT post.cybercity DOT dk <=
|
|
|