[Veritas-bu] Robot Contents Mismatch
2004-06-02 10:08:09
Do you have barcode rules set up? If so, you could try this:
/usr/openv/volmgr/bin/vmupdate -rn robot_number -rt tape_type
-use_barcode_rules
That will do the compare, and update everything to match. Make sure to
set robot_number and tape_type to match your environment.
Best of luck,
-dd
>>> "Arif Budiman" <ArifB AT excelcom.co DOT id> 6/1/2004 7:33:30 PM >>>
I often find Robot contents are mismatch with volume configuration. If
I
compare robot contents and volume configuration from Robot Inventory
menu, I got result like bellow lines. And if I run perform volume
configuration update I got failure message "media ID not unique in
database (34)". From Media And Device Management->Media menu, there is
no media visible.
This condition cause any active backup sechedule failed with error
code
96 (Unable to allocate new media for backup, storage unit has none
available).
Any idea?
--------------------------------------------------------------------
06/02/2004 09:30:25
Robot: TLD(0) on datamover2
Operation: Compare Robot Contents
Volume Database Host: datamover2
--------------------------------------------------------------------
Robot Contents Volume Configuration
Slot Tape Barcode Media ID Barcode Mismatch
Detected
==== ==== ============= ======== =============
=================
1 Yes STK463 Yes
2 Yes STK706 Yes
3 Yes STK705 Yes
4 Yes DC0185 Yes
5 Yes DC0192 Yes
.
.
Regards,
Arif Budiman
NOC - Data Backup Engineer
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|