Jason,
Vault catalog tape is not supposed to use any tape from the scratch
pool. You must specify tapes for vault catalog backup, otherwise you
will end up more works later.
Tommy
-----Original Message-----
From: veritas-bu-admin AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-admin AT mailman.eng.auburn DOT edu] On Behalf Of
Jason_Cordes/US/Enbridge AT enbridge-us DOT com
Sent: Wednesday, December 10, 2003 10:42 AM
To: veritas-bu AT mailman.eng.auburn DOT edu;
veritas-bu-admin AT mailman.eng.auburn DOT edu
Subject: RE: [Veritas-bu] Catalog backup failed; no media available
That may be what the manual says but that is not the behavior I see in
my
installation. I have NBU4.5fp5 running on Win2k and for the catalog
backup,
yes you need to manually assign tapes for that to run and those 1 or 2
tapes you assign are alway uses and reused for catalog backups until you
deassign them.
Vault is another story, it will take a tape from the scratch pool to
vault
the catalog backup. Vault takes a tape from the scratch pool and moves
it
to the Netbackup pool and does it's own catalog backup.
-jason
Joe Royer
<jroyer AT colltech DOT com> To: Jon
Walton <jonw AT n2h2 DOT com>
Sent by: cc:
"Donaldson, Mark" <Mark.Donaldson AT experianems DOT com>,
veritas-bu-admin AT mailman DOT eng.
"'RAldinger AT foxpitt DOT com'" <RAldinger AT foxpitt DOT com>,
auburn.edu
veritas-bu AT mailman.eng.auburn DOT edu
Subject:
RE: [Veritas-bu] Catalog backup failed; no media available
12/09/2003 11:45 PM
I disagree. p.17 of Vault 4.5 SAG says:
Note: NetBackup does not automatically move media to the catalog
backup pool from the scratch pool. You must monitor the media in this
pool for use. There must be a tape in the catalog volume pool before
the Vault session runs. If there are no available tapes in the catalog
volume pool, the session will fail.
And again on p.106 under Ensuring Available Media for Catalog Backups
Please correct me if I'm missing something.
On Tue, 9 Dec 2003, Jon Walton wrote:
> If we are talking about 4.5 Vault, it does pull from the scratch pool.
> 3.4 Vault requires the preallocation.
>
> (From the Vault Admin guide)
>
> Note If you use a scratch pool, Vault will allocate volumes from the
> scratch pool to the catalog volume pool if needed. However, Vault will
not
> return expired catalog volumes back to the scratch pool because
NetBackup
> never overwrites catalog media, even expired Vault catalog backup
media.
> Vault returns expired catalog volumes back to the catalog volume pool.
>
> -Jon
>
> On Tue, 9 Dec 2003, Donaldson, Mark wrote:
>
> > The catalog backup will not pick from the scratch pool. You have to
> > hard-assign (up to two) specific tapes to the catalog backup. You
can
do
> > this most-easily via the GUI.
> > -M
> >
> > -----Original Message-----
> > From: RAldinger AT foxpitt DOT com [mailto:RAldinger AT foxpitt DOT com]
> > Sent: Tuesday, December 09, 2003 6:55 AM
> > To: veritas-bu AT mailman.eng.auburn DOT edu
> > Subject: [Veritas-bu] Catalog backup failed; no media available
> >
> >
> > Netbackup DataCenter 4.5GA
> > Windows 2000 Server - Service pack 4
> >
> > Vault option runs fine, however, the catalog backup fails
continuosly.
> > Error - Catalog backup failed; no media available
> >
> > There are plenty of tapes in the scratch pool, I do not know what to
check.
> >
> > Any help would be appreciated.
> >
> > Thanks!
> >
>
--
D. Joe Royer II Collective Technologies
CCNA, CISSP, VCP http://www.colltech.com/
jroyer AT colltech DOT com
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
