Hello Will

On solaris you could do

iostat -xnM 1 | grep rmt

to get the throughput on the tapedrives while the restore is running

Another possibility is
bperror -jobid <restore jobid> and use bc to calculate total Kb and Elapsed 
seconds

Regards
Michael

On Wed, 27 Aug 2003 11:47:09 -0400, William Enestvedt wrote
> Is there a place to get throughput statistics for a Restore, either 
> after it's done or while it's running? I'm thinking either a count 
> of raw Kb and the Elapsed Time, or the kind of pretty figures 
> produced by the bperror command.   I run NBU 3.4 Data Center on 
> Solaris 8 with a couple of L9s (DLT8000) and an L25 (SDLT).   Thanks 
> in advance. -wde
> --
> Will Enestvedt
> UNIX System Administrator
> Johnson & Wales University -- Providence, RI
> William.Enestvedt AT jwu DOT edu
> Phone: (401) 598-1584 -- Cell: (401) 258-9169
> 
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu


--
Cybercity Webhosting (http://www.cybercity.dk)