I think this will work for you if you're running Windows.  If not, maybe
somebody else can translate this procedure to *nix.

1.  In Device Monitor, click View | Customize
2.  Click the Preferences tab
3.  Select Enable 'Up Drive, Operator Control'
4.  Right-click the drive in device manager and choose to up with opeartor
control (may have to restart device manager service)

Good luck,
Matt

-----Original Message-----
From: Carlos Perales [mailto:Carlos.Perales AT kellogg DOT com] 
Sent: Thursday, November 07, 2002 10:07 AM
To: veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] DLT Drive Config





All,

I'm having a problem configuring a DLT drive.
I want to add it as an standalone drive.

It's a DLT7000.

Every time I add it, it's shown as AVR

                                  DRIVE STATUS

Drv Type   Control  User      Label  RVSN    EVSN    Ready   Wr.Enbl.  ReqId
  0 4mm      OPR               Yes   WED-B            Yes     Yes       -
  1 dlt      AVR                -                     No       -        -

Any ideas ?
I know there are options to configure the drive (DLT, DLT2 and DLT3).
I have tried all of them, however, is there any special I should use ?

Thanks a lot !

Carlos




_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu