Hello everyone - Hope are you are all ok?
I got a small question about Compression! In Netbackup Policy Management,
you can define "Software" Compression by choosing the Tick box on the
Attributes Tab.

However, I was advised that my ADIC Scalar 100 comes with Hardware
Compression. I am trying to identify how I can determine if Hardware
Compression is being used. My reason for asking this is because we done a
109GB Backup which spread over 2 tapes. We use LTO 200GB Compressed Tapes.
Surely this should have gone onto the same tape?

Does anyone know the best way to check the ADIC for compression?

Thank you.

Simon Weaver
NT Domain Administrator
Ext. 5544
Tel: 02392-705544 (Direct Dial)
Simon.Weaver AT Astrium-Space DOT com

...
This email is for the intended addressee only.
If you have received it in error then you must not use, retain, disseminate
or otherwise deal with it.  Please notify the sender by return email.
The views of the author may not necessarily constitute the views of Astrium 
Limited.
Nothing in this email shall bind Astrium Limited in any contract or obligation.

Astrium Limited, Registered in England and Wales No. 2449259
Registered Office: Gunnels Wood Road, Stevenage, Hertfordshire, SG1 2AS, England