Hi Guys
I would like some advice from NT Admins using Netbackup in an NT
Environment.
Our sister company lost a Compaq Array, which had to be replaced.
Consequently, they lost the NT Volume set too!! (Logical Drive letter was
E).

There were also additional arrays to this Logical drive, but because of the
damage, it was decided to erase everything, add the new array and recreate
the volume set.

The data was restored successfully.

Now, whenever backups are performed, the performance is terrible (122kb/s,
35kb/s)!!! We are sometimes lucky if we get 2MB/s but this is now a rare
occurance.

Backups are also not completing successfully.
A call has been placed with Veritas, but found nothing wrong with the
software, and they blame the Hardware.

I wonder if anyone else has come across a problem like this in an NT
Environment? 
I would be extremely grateful for anyones input here! If there is anything I
could do then please tell me :)
Thank you

Simon Weaver
NT Domain Administrator
Ext. 5544
Tel: 02392-705544 (Direct Dial)
Simon.Weaver AT Astrium-Space DOT com

...
This email is for the intended addressee only.
If you have received it in error then you must not use, retain, disseminate
or otherwise deal with it.  Please notify the sender by return email.
The views of the author may not necessarily constitute the views of Astrium 
Limited.
Nothing in this email shall bind Astrium Limited in any contract or obligation.

Astrium Limited, Registered in England and Wales No. 2449259
Registered Office: Gunnels Wood Road, Stevenage, Hertfordshire, SG1 2AS, England