Jeff,

You don't say which version of NBU you are running...but from the NBU v4.5
"Media Manager Device Configuration Guide" pages 18 and 19, VERITAS says:


"QUANTUM DLT7000", "Quantum DLT7000 Tape Drive", "Q-DLT7000",

Q-DLT7000 = 1,0x38,0,0x19639,4,0x82,0x83,0x84,0x85,3;


________________________________________

Bill Wiessner
Sr. Staff Systems Engineer
VERITAS Software Corporation

Office:  410-877-7689 
Cell:     410-804-3321
mailto:bill.wiessner AT veritas DOT com
http://www.veritas.com/

________________________________________

 -----Original Message-----
From:   Jeff Kennedy [mailto:jlkennedy AT amcc DOT com] 
Sent:   Tuesday, July 23, 2002 11:58 AM
To:     NBU List
Subject:        [Veritas-bu] st.conf entries for DLT7k

I am getting conflicting stories on what should go in st.conf for the
DLT 7k.

ATL says the following:

tape-config-list=
        "QUANTUM DLT7000",      "DLT 7000",                     "DLT7000",
        DLT7000         =       1,0x38,0,0x8639,4,0x82,0x83,0x84,0x85,3;

However, Sun says the following:

tape-config-list=
        "QUANTUM DLT7000",      "QUANTUM DLT7000", "DLT7k-data";
        DLT7k-data =    1,0x36,0,0x1D639,4,0x82,0x83,0x84,0x85,2;

And the main reason I post this is that with ATL's entry for DLT7k I get
unexpected token errors from st.conf.  Funny thing though, the SDLT
entry is fine.

Can anyone verify a Solaris st.conf dlt7k entry for an ATL library for
me?

Thanks.
-- 
=====================
Jeff Kennedy
Unix Administrator
AMCC
jlkennedy AT amcc DOT com
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu