[Veritas-bu] Re-using Arcserve tapes

Subject:	[Veritas-bu] Re-using Arcserve tapes
From:	david AT xbpadm-commands DOT com (david AT xbpadm-commands DOT com)
Date:	Tue, 9 Apr 2002 17:35:24 -0400

I can't remember if Arcserve has the MTF1 format on there or not, but you may 
want to test it out.  If it doesn't freeze the tape you are good to go, if it 
does you'll have to bplabel those tapes.

David

Quoting "Conner, Neil" <neil AT mbari DOT org>:

> I have a bunch of Arcserve v6.1 AIT2 tapes I want to re-use with NetBackup. 
> Is there anything I need to do other than slapping a bar-code label on
> them?
> 
> -Neil
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>

<Prev in Thread]	Current Thread	[Next in Thread>
[Veritas-bu] Re-using Arcserve tapes, Conner, Neil [Veritas-bu] Re-using Arcserve tapes, Jim VandeVegt [Veritas-bu] Re-using Arcserve tapes, david AT xbpadm-commands DOT com <= [Veritas-bu] Re-using Arcserve tapes, Keith Morse [Veritas-bu] Re-using Arcserve tapes, scott.kendall AT abbott DOT com [Veritas-bu] Re-using Arcserve tapes, Conner, Neil

Previous by Date:	[Veritas-bu] tape load command, jmoulton AT languageline DOT com
Next by Date:	[Veritas-bu] NEW_STREAM Question, david AT xbpadm-commands DOT com
Previous by Thread:	[Veritas-bu] Re-using Arcserve tapes, Jim VandeVegt
Next by Thread:	[Veritas-bu] Re-using Arcserve tapes, Keith Morse
Indexes:	[Date] [Thread] [Top] [All Lists]