Veritas-bu

[Veritas-bu] Current tape in drive

2002-04-08 12:09:34
Subject: [Veritas-bu] Current tape in drive
From: david AT xbpadm-commands DOT com (David A. Chapa)
Date: Mon, 8 Apr 2002 11:09:34 -0500
vmoprcmd is the only command that queries the database needed to get this
information regarding the standalone drive from NetBackup.

Any reason why you wouldn't want to use it?

David



<><><><><><><><><><><><><><><><><><><><>
David A. Chapa
NetBackup Consultant
DataStaff, Inc.
http://www.consulting.datastaff.com
847 413 1144
---------------------------------------
NBU-LSERV AT datastaff DOT com - Adv. Scripting
http://www.xbpadm-commands.com

-----Original Message-----
From: veritas-bu-admin AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-admin AT mailman.eng.auburn DOT edu]On Behalf Of Williams,
Kris
Sent: Monday, April 08, 2002 8:56 AM
To: 'veritas-bu AT mailman.eng.auburn DOT edu'
Subject: [Veritas-bu] Current tape in drive


Does anyone have an example of a script that goes out and checks the current
tape loaded in a standalone drive on a NT/2000 box? Basically what I want to
do
is run a script everyday after our remote contacts change the tape and make
sure
the correct tape is in the drive. My problem is getting the tape that is
currently loaded in the drive. VMOPRCMD does this, but it would be nice if I
could get this information from somewhere else. Any ideas?



Thanks,

me
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu


<Prev in Thread] Current Thread [Next in Thread>