But normally the retention level should be same on one tape unless you
specify to allow multi-retention level in the same tape. So in this
scenario, I think to change the retention level for the whole tape will be
better.

Just my 2 cents comments.

-----------------------
Thanks
ldf
----- Original Message -----
From: "Michael Suen" <suen AT cosmos.buffalo DOT edu>
Cc: "Veritas-Bu (E-mail)" <veritas-bu AT mailman.eng.auburn DOT edu>
Sent: Tuesday, March 05, 2002 11:06 PM
Subject: [Veritas-bu] More duplicate images questions


>
> Hello EveryOne...
>
> I just have a few more Duplicate images questions...
> Is that possible to change the retension on the second copy of the
> image.... NOT the whole media.
> The bpexpdate -recalculate doesn't have a -copy option.
> I would like to be able to change the second copy of a specific
> backup image...
>
> Thanks
>
> Is that possible to list/find out where is the first and second
> copy of my image? I was able to dup an image from disk to tape
> but I was only able to see that specific image, copy number 2
> with the Media ID of the "copy". Is that possible to list
> the location (Media id) of the primary and copy...
>
>
> Thank you very much for everybody's help..
>
> thx
>
> mike
>
>
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu