James,
Thanks. I noticed the bpdbjobs command waiting on a read system call, after
typing refresh it read all the files again.
David
-----Original Message-----
From: James Mello [mailto:kingjamm AT colltech DOT com]
Sent: Friday, December 07, 2001 9:15 AM
To: Smith, David W (IT)
Cc: 'veritas-bu AT mailman.eng.auburn DOT edu'; Smith, David W (IT)
Subject: Re: [Veritas-bu] Veritas NetBackup: Using bpdbjobs in a "tail
-f" mode?
bpdbjobs -report -all_columns -stay_alive
You need to either have a while loop that puts in the value "refresh" or
type it by hand...
-- Cheers
-- James
On Fri, 7 Dec 2001, Smith, David W (IT) wrote:
>
> Does anyone know of a method to us the bpdbjobs command in like a unix
"tail
> -f" mode, where you can continually monitor jobs being run, etc.
>
> Does this command have a man page? I've looked in the System Admin manual
> and the options are not documented well.
>
> Thanks,
>
> David W. Smith (David.W.Smith AT kla-tencor DOT com)
> KLA-Tencor Corporation
> Telephone: 408-875-6856 (direct) 408-571-2700 (fax)
> Pager : 888-476-5501 (numeric) 0951038 AT pagenet DOT net (alpha)
> _______________________________________________
> Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>
|