I'm trying to perform a manual cleaning, I have a storage device that uses
a robot and has 2 quantum dlt drives. Everythings configured fine, my
backups verify that, when I try to run the tpclean command and specify the
second drive, it cleans the first drive. I give it the name that the drive
was assigned when we did the install, I also tried it by device name, ran
the tpconfig -d command to verify what I was looking at in the gui. I even
went as far as downing the first drive then trying it, the cleaning tape
goes to drive1 everytime, anyone seen that one before?
Kevin
|