The setup found under PC_Clnt is all that is needed for the NetBackup client
on an NT box.
The administration client allows you to do everything that can be done
directly from the master, but from a remote machine. It is only needed on the
machine where you're going to be managing the environment and it will not work
until the workstation running the admin utilities is added to the server list
on the master. If you're going to use this utility to remotely change
settings on media servers/clients, the workstations name must also be in the
server list for all of the media servers/clients.
OTM will not show up with a tab in the clients GUI. It can be modified
directly in the Registry or changed with the admin utility mentioned above.
The client's properties under the "configure NetBackup" section of the admin
utility is where you'll find the OTM tab that the manual talks about.
- Scott
effendy yahaya
<darkburst AT yahoo DOT com> To: Veritas
Mailling List <veritas-bu AT mailman.eng.auburn DOT edu>
Sent by: cc: effendyeds AT
yahoo DOT com
veritas-bu-admin AT mailman DOT eng. Subject:
[Veritas-bu] NT as client and OTM
auburn.edu
06/18/2001 04:49 PM
hi,
which are the correct package need to installed on NT
as a client. Is it under the PC_Clnt ? Do i need to
install the gui administration ? currently my client
are working fine without any patches installed on it,
except that i couldn't find any OTM tab. then, i can
i reconfigure OTM ?
i'm using NT 4.0 SP5, TCP/IP network.
Regards,
Effendy
__________________________________________________
Do You Yahoo!?
Spot the hottest trends in music, movies, and more.
http://buzz.yahoo.com/
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
