[Veritas-bu] Help on NDMP

You need to look at how you configuref your storage unit.

Bpsched will fork a process which checks the drive status.  This fork
process uses what you have configured for the storage unit.

> -----Original Message-----
> From: veritas-bu-admin AT mailman.eng.auburn DOT edu
> [mailto:veritas-bu-admin AT mailman.eng.auburn DOT edu]On Behalf Of Axel Kunze
> Sent: Friday, June 15, 2001 5:25 AM
> To: veritas-bu AT mailman.eng.auburn DOT edu
> Subject: [Veritas-bu] Help on NDMP
>
>
> Hello everybody !
>
> I'm now getting crazy with this NDMP ....
>
> I configured our NetApp Filer with 2 DLT7000 out of the STK 9740
> Library. In the
> Device Manager the drives are available via /ndmp/... and UP. Fine ...
> I want my Solaris Box to control the STK and the other 6 drives,
> so I left the
> robotic control, where it was ...
> This is what tpconfig shows now:
>
>   0   QUANTUMDLT70000        /dev/rmt/0cbn            dlt      No
>        UP
>         ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=0
>   1   QUANTUMDLT70001        /dev/rmt/1cbn            dlt      No
>        UP
>         ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=1
>   2   QUANTUMDLT70002        /dev/rmt/2cbn            dlt      No
>        UP
>         ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=2
>   3   QUANTUMDLT70003        /dev/rmt/3cbn            dlt      No
>        UP
>         ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=3
>   4   QUANTUMDLT70004        /dev/rmt/4cbn            dlt      No
>        UP
>         ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=4
>   5   QUANTUMDLT70005        /dev/rmt/5cbn            dlt      No
>        UP
>         ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=5
>   6   DAB-FS30_STK9740_Drive /ndmp/nrst0a             dlt      No
>        UP
>         ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=6
>   7   DAB-FS30_STK9740_Drive /ndmp/nrst1a             dlt      No
>        UP
>         ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=7
>
> The set_ndmp_attr -verify are running as well ...
>
> Now I set up a NDMP Class with a NDMP Client, start a manual
> backup and Netbackup queues
> the job and ends up with code 213 - no storage units available for use ...
>
> Where did I misconfigure this device configuration ?!?
>
> Regards
>
> Axel Kunze
>
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>