Veritas-bu

[Veritas-bu] Ejecting tapes from a TLD robot.

2001-06-04 16:46:31
Subject: [Veritas-bu] Ejecting tapes from a TLD robot.
From: Douglas.Ritschel AT fnc.fujitsu DOT com (Douglas Ritschel)
Date: Mon, 04 Jun 2001 16:46:31 -0400
This worked, thanks. 


John_Wang AT enron DOT net wrote:
> 
> Hello Douglas
> 
> This was discussed on the list before.   Apparently there's an undocumented 
> flag
> to the vmchange command that ejects the tapes.   Depending on your robot, it 
> may
> work.   The command line will be something like:
> 
>      /usr/openv/volmgr/bin/vmchange -res -m $TAPE -mt dlt -v OFFSITE -e
> 
> However, with an ADIC Scalar 1000, it will eject a single tape, wait a few
> seconds, take the tape from the IE station and put it back in the library and
> claim that it can't eject the tape because the IE slot was already occupied
> however it will have recorded the tape as having been ejected.   I think 
> there's
> an inversion in the Scalar 1000 firmware for the routine that checks if the 
> slot
> is occupied i.e.: it ejects first then checks to see if the destination IE 
> slot
> is occupied.   If anyone with a Scalar 1000 is out there, I'd appreciate
> verification on this or better yet a solution.
> 
> Regards,
> John I Wang
> Sr. Systems Engineer
> Steverson Information Professionals
> 
> ---
> Enron Networks
> Enron Building room 3427e
> ph (713) 345-4888
> cell (832) 493-1263
> fax (713) 646-8462
> pg pagejwang AT skytel DOT com or 1-877-390-4155
> 
> |--------+-------------------------------->
> |        |          [email protected]|
> |        |          ujitsu.com            |
> |        |                                |
> |        |          06/04/01 12:23 PM     |
> |        |                                |
> |--------+-------------------------------->
>   >----------------------------------------------------------|
>   |                                                          |
>   |       To:     veritas-bu AT mailman.eng.auburn DOT edu          |
>   |       cc:     (bcc: John Wang/Contractor/Enron           |
>   |       Communications)                                    |
>   |       Subject:     [Veritas-bu] Ejecting tapes from a TLD|
>   |       robot.                                             |
>   >----------------------------------------------------------|
> 
> I'm using Netbackup 3.4 Data Center. Does anyone know if there is a
> command for ejecting tapes from a TLD robotic library, rather than using
> the GUI?
> 
> --
> Douglas Ritschel
> Fujitsu Network Communications
> Two Blue Hill Plaza, Sixth Floor
> P.O. Box 1609
> Pearl River, NY 10965
> Ph: 845-731-2101 Fx: 845-731-2011
> Douglas.Ritschel AT fnc.fujitsu DOT com
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
> 
> _______________________________________________
> Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu

-- 
Douglas Ritschel
Fujitsu Network Communications
Two Blue Hill Plaza, Sixth Floor
P.O. Box 1609
Pearl River, NY 10965
Ph: 845-731-2101 Fx: 845-731-2011
Douglas.Ritschel AT fnc.fujitsu DOT com