[Veritas-bu] Cleaning tape
2000-11-27 17:06:42
Dale,
If you open the robot/silo and look up and to the right
you should see a little diagram that tells you in which
slot to place cleaning and/or diag tapes into. You must
have the appropriate label on the cleaning tape. Just put
it in the right slot and close up the robot. When it completes
it inventory it will then know that there is a cleaning tape
in it and will use it on an as need basis it that option is
turned on. This can be done from the front panel display.
You can also set the max. number of cleanings and the display
will indicate if that has been exceeded. You can also replace
the cleaning tape from an option using the front panel display
as well.
Hope this helps ... :)
--
--Lee
Client Site: EATON Corp. Cleveland OH (440) 954-5626
----------------------_-----------------------_--------------------------
Lee S. Kolinsky |_| C o l l e c t i v e |_| kolinsky AT colltech DOT com
Pager: 800/946-4646 |___ Technologies ___| http://www.colltech.com
Pin #: 148-3408 O O "The Power Of Many Minds"
-------------------------------------------------------------------------
What the large print giveth, the small print taketh away.
|
|
|