Hi David,
It works.
We are running such a setup - our server is 7.6.4 backing up an Exchange 2010 
server using nmm24.build375 ... 
We Have tested restores also and they work...
Mailbox / folder restores require the backup be written to / and the restore to 
be read from an AFT device (we're using disk). We can only keep the past 3 days 
on disk due to space constraints, then they are staged off to tape after 68 
hours... 

Paul

-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On 
Behalf Of Browning, David
Sent: Thursday, July 18, 2013 2:43 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: Re: [Networker] NMM 2.4 sp1 and Exchange 2013 sp3

I apologize, it is Exchange 2010 SP3, not Exchange 2013.   

David M. Browning Jr.
IT Project Coordinator Enterprise Backups and Help Desk 
http://www.lsuhsc.edu/ithelpdesk
Twitter: @LSUHSCNO_IT 



-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On 
Behalf Of Browning, David
Sent: Thursday, July 18, 2013 1:38 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] NMM 2.4 sp1 and Exchange 2013 sp3

Our Exchange administrators are in the process of upgrading our Exchange 2013 
servers to SP3, and we have some questions.    Right now, our backup server is 
running 7.6.2.7, with a planned upgrade to 8.0.sp2 in September.    In order to 
run NMM2.4sp1, according to the EMC web site, we must have the Exchange client 
on NW 8.0sp1 (or higher).    

We are concerned about the backup server running 7.6.2.7, and the client 
running 8.0sp2, and NMM 2.4sp1.   

Is anyone else running this configuration out there?  Any issues?   

Thanks. 

David M. Browning Jr.
IT Project Coordinator Enterprise Backups and Help Desk 
http://www.lsuhsc.edu/ithelpdesk
Twitter: @LSUHSCNO_IT