[Networker] Fixing a damaged cartridge?
2012-04-27 17:53:20
Hi,
If you had an LTO-4 tape that was physically damaged as far as the
cartridge casing, so you didn't want to risk loading into a drive, but
the tape was otherwise fine, is it easy to take it apart (unscrew) and
re-insert the tape reel into another new cartridge?
Obviously, you'd have to be careful to line up the leader pin correctly
so it looks the same as far as how it's positioned when looking through
the slider shutter on the side. Seems to me I played around with an old
LTO-3 or LTO-1 scratch tape one time (same construction on the case as
two pieces with screws), and it was not trivial as it was under tension
and just flew all over the place, parts, spring, etc. making it
difficult to reassemble reliably, parts, etc. Has anyone ever done this
before? Is it tricky and not advised? What would be the best way to test
that you had done it correctly?
Obviously, if it was a clone volume, and you still have the original
volume(s), you could simply re-clone it, and take that tape out of
circulation but just asking. Thought I'd seen some documentation on this
before, but just wanted to get the opinion of folks here.
No this isn't necessary, just theorizing.
George
--
George Sinclair
Voice: (301) 713-3284 x210
- The preceding message is personal and does not reflect any official or
unofficial position of the United States Department of Commerce -
- Any opinions expressed in this message are NOT those of the US Govt. -
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [Networker] Fixing a damaged cartridge?,
George Sinclair <=
|
|
|