If you changed hardware, this means you have a new host-id, which requires new 
authcodes for your enablers... I would contact EMC licensing , provide them the 
new host-id to get new authcodes. Authcodes are tied to your hardware via the 
host-id.

-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On 
Behalf Of Eugene Vilensky
Sent: Thursday, September 22, 2011 2:11 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: Re: [Networker] Linux upgrades and License Conformance

On Thu, Sep 22, 2011 at 12:07 PM, Chester Martin <cmartin AT spp DOT org> wrote:
> That didn't happen to me when I upgraded, but I upgraded from 7.6.0.  I think 
> from 7.5 to 7.6 >networker automatically enters the upgrade license code. 
>  Now from 7.4 to 7.5 I had to get a >code to put in manually.  Did you 
> upgrade from a version older than 7.5?

Historically speaking, this server is newer hardware but the /nsr/ was
copied from a 7.2 server, upgraded to 7.4 then 7.6.2.  I had all the
right enablers and license transfers to 7.6.2 and later took it to
7.6.2.2 without noticing anything about EVALUATION mode.  Weird.

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER