Networker

Re: [Networker] How to route save job to a storage node

2010-11-29 15:05:40
Subject: Re: [Networker] How to route save job to a storage node
From: "Bremner, David" <David.Bremner AT GWL DOT CA>
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Date: Mon, 29 Nov 2010 14:04:25 -0600
I'm not sure if I'm reading this right but in the client's properties
under "Globals (2 of 2)" did you try adding the storage node to the
"storage nodes" field instead of nsrserverhost?

David Bremner
Technical Specialist, Enterprise Storage Support
Great-West Life / Investors Group
London Life / Canada Life

Phone: (204) 924-2422
-------------------------------------------------------------
E-mail disclaimer
The contents of this communication, including any attachment(s), are
confidential and may be privileged. If you are not the intended
recipient (or are not receiving this communication on behalf of the
intended recipient), please notify the sender immediately and delete or
destroy this communication without reading it, and without making,
forwarding, or retaining any copy or record of it or its contents. Thank
you. Note: We have taken precautions against viruses, but take no
responsibility for loss or damage caused by any virus present.



-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of Michael Leone
Sent: Monday, November 29, 2010 1:57 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] How to route save job to a storage node


I am confused about something. I have a save job that I need to write to
a 
tape drive on a storage node, and not to the tape drive on the Networker

server. I know how to do that for clones - by listing the storage node 
under "Clone Storage Nodes" in the "Globals 2" tab of the appropriate 
client definition. But how do I specify a non-clone client to save to
the 
tape drive on a storage node, instead of the Networker server? The tape 
drive is in the appropriate pool, and is mounted. The storage node is
not 
a dedicated storage node (that I can see - the drives on the node do not

say dedicated). But I don't see where in the client definition I can
list 
the storage node as a valid save device; all the sections speak of
storage 
nodes ...

My first time trying to do this. Can someone point me in the right 
direction?

-- 
Michael Leone
Network Administrator, ISM
Philadelphia Housing Authority
2500 Jackson St
Philadelphia, PA 19145
Tel:  215-684-4180
Cell: 215-252-0143
<mailto:michael.leone AT pha.phila DOT gov>

To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or via RSS at
http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER