In older releases of NW (e.g. 7.2.2) , it used to be that when you
restarted a failed group, using nwadmin, it would only rerun the
clients/savesets that failed, not the ones that succeeded. On the other
hand, if you did a 'Start' then natch.
On newer releases (7.5.x), the 'Restart' option under nmc reruns
everything. Is there a way to force it to just rerun the failed client?
So I have group that shows up under nmc with a status as a red circle
with an 'X' in it, not a checkbox with a green check mark. That means
something failed. Turns out, one client failed because the client
software was turned off. After turning it back on and restarting the
client, I now want to rerun the failed client. I can either 'Start' or
'Restart'. I pick 'Restart', and it restarts every client. Sheesh!
Do I have to instead login to the primary backup server and run:
savegrp -l incr group -c client
Yes, I can do that, but thought maybe nmc could do this, too?
Thanks.
George
--
George Sinclair
Voice: (301) 713-3284 x210
- The preceding message is personal and does not reflect any official or
unofficial position of the United States Department of Commerce -
- Any opinions expressed in this message are NOT those of the US Govt. -
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|