Re: [Networker] Port numbers for NMC?

On 10/15/09 7:16 PM, George Sinclair wrote:

1. I thought I remember reading somewhere - maybe on this listing -about some command to set ports that you're supposed to run beforeinstalling NW on the server? Maybe that was something else entirely?

I assume you are referring to the nsrports command -- that is for the NetWorker server softwareitself and is not relevant to NMC.


2. Do most folks use the defaults?


I do.


3. I assume the installation will prompt for these?


It will.


4. Best way to change these values later?

I never have. What version are you installing.... NW7.5's NMC uses a different configurationthan the previous versions did.


Thanks.



--
Frank Swasey                    | http://www.uvm.edu/~fcs
Sr Systems Administrator        | Always remember: You are UNIQUE,
University of Vermont           |    just like everyone else.
  "I am not young enough to know everything." - Oscar Wilde (1854-1900)

To sign off this list, send email to listserv AT listserv.temple DOT edu and type 
"signoff networker" in the body of the email. Please write to networker-request 
AT listserv.temple DOT edu if you have any problems with this list. You can access the 
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER