It's consistent in that anything less than 10G is displayed in the
thousands of MB (e.g. 6499 MB and not 6.5 GB) and anything over 10 GB is
displayed in GB.

Thanks,

Dana
> -----Original Message-----
> From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU]
On
> Behalf Of Teresa Biehler
> Sent: Thursday, June 19, 2008 10:01 AM
> To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
> Subject: mminfo and sizes
> 
> Hi,
> 
> 
> 
> I'd like to find out how much data is written to a piece of media
(could
> be disk, could be tape).  So, I use mmifo.  Unfortunately, it changes
> the units it reports the size in based on the size.  For example:
> 
> 
> 
> mminfo -q " volume=000999" -r "volume,written"
> 
>  volume        written
> 
> 000999           14 GB
> 
> 
> 
> mminfo -q "volume=000039" -r "volume,written"
> 
>  volume        written
> 
> 000039         6499 MB
> 
> 
> 
> 
> 
> Is there a way to force mminfo to be consistent?
> 
> 
> 
> Thanks.
> 
> Teresa
> 
> 
> To sign off this list, send email to listserv AT listserv.temple DOT edu and
type
> "signoff networker" in the body of the email. Please write to
networker-
> request AT listserv.temple DOT edu if you have any problems with this list.
You
> can access the archives at
> http://listserv.temple.edu/archives/networker.html or
> via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER