[Networker] NW Clone question on source and target drives
2008-04-04 14:40:02
Having difficulty forcing a clone session to use the source and target
drives on the NW server. The client config and backup I am cloning has
nsrserverhost set in the storage node (globals 2 of 2), and clone storage
node (this paramter is only for the save side). The source volume always
gets mounted on one of our storage nodes, and the target always gets
mounted on the NW server (nsrserverhost). The data travels over the
network, which is bad. I uderstand that legato will use the storage node
the backups was done on, but according to the client config that should
not happen - it should be the NW server.
Does anyone have any comments on this setup? Thanks.
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|