Re: [Networker] Tape showing in drive but it isnt
2008-01-03 14:51:36
EMC NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU> wrote on
01/03/2008 02:09:12 PM:
> No I actually have 11 drives so for some reason one of them doesn't
> show as "active".
>
> I tried ejecting the tape with the sjimm command (or the library
> gui) and reinventorying but it won't inventory that drive since it's
> not "active". The only way I've found to get it to work again is to
> restart the Networker services.
Did the drive go into "service mode"? I have a library that does that
sometimes - 1 drive of 4 will show enough errors (for whatever reasons)
that NetWorker takes it offline. I would check the NetWorker properties of
the library to ensure that all drives are in "ready" mode.
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|