Re: [Networker] Setting Volume location via command line.
2007-12-21 15:36:48
>From a command line you can run the following
mmlocate -u -n 'location'
Ken Ciolek, LCNA
Storage Consultant
Glasshouse Technologies, Inc.
Mobile: 201 232 6682
PCS: 201 208 3736
eFax: 201 603 6405
ken.ciolek AT glasshouse DOT com
www.glasshouse.com
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of Cox, Shawn
Sent: Friday, December 21, 2007 3:08 PM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Setting Volume location via command line.
What app would I use to set the Volume location via command line?
--Shawn
--------------------------------------------------
Server and Storage Administrator
Plains Cotton Cooperative Association
Lubbock, Texas
(806)763-8011
--------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|