Re: [Networker] Install a remote Storage Node
2007-12-21 07:14:16
On Dec 20, 2007, at 11:04 PM, Peter Viertel wrote:
Nsrlcpd is started as a process on the storage node when the
autochanger
is enabled... You should go to devices in NMC - look under library
tree and right button on the library to see if you can Enable it...
If nsrlcpd doesn't start you might have an issue with your storage
node
config...
On the storage node you need both the client and storage node
packages..
The servers file on the storage node has to have the server in it,
maybe
that's not right...
For all your clients, you must have the *server* in their servers
file -
not much value in having the storage node listed.
If all looks good - then perhaps the fact that fqdn's are being
reported
in the log may point to an issue with dns - your client records -
including the client record for the sn should be unqualified names,
the
fqdn's should be in the aliases list for the client though.
Networker is very touchy with dns because it relies a lot on dns
reverse
lookups.
Just in case its not clear, any change to the /nsr/res/servers file
must be followed by restarting the NetWorker software on the system
where the change was made.
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- Re: [Networker] Install a remote Storage Node, (continued)
|
|
|